Alles anzeigenFalls jemand wie ich Probleme beim Updaten der installierten Version hat:
1. A340 deinstallieren
2. Update laden
3. Sim schließen und neu starten
4. Neue Version installieren.
Falls 'installation failed' kommt:
Sim schließen, PC neu starten (kann nie schaden)
Dann wieder im MP den A340 runterladen und dann sollte er installieren.
Wäre ja zu einfach, wenn es einfach mal ohne gedöns funktionieren würde.
Hier nochmal das Vorgehen 👍👍
V1.0.3
SYSTEMS ⚙️
FIXED Memo: missing MAN LDG ELEV when using the overhead knob
FIXED Gravity gear not working with GREEN SYS failure and selected down
FIXED When DC 1 + 2 fault gear will not come down even with gravity EXT
FIXED IR issue still not fixed and this is what caused drama on 350. When IR 1 is elected off the ATT for PFD 1 is lost same for IR 2 and FO PFD and follows the same logic on the ECAM SWTCH panel so you can use the IR INFO from IR 3 on either FO or CPT PFD
FIXED IR Advisory logic revised
FIXED GPWS & Terrain behavior in case of no AC power or ADIRU 1 fault
FIXED Add FWC 1+2 FAULT behavior
FIXED F speed > Vfe CONF2 at high weights
FIXED Important: LG gravity extension incorrectly modelled
FIXED Engine Oil step in checklist not achievable
FIXED ND Deficiencies on Short Flights
FIXED FPLAN DIST limit
FIXED CRZ WIND Page missing when it shouldn't
FIXED Oxygen Mask test logic revised
FIXED Restore Toggle Reverse/Reverse Hold functionality
FIXED Cabin doesn't ready all of the time
FIXED EIS2-FUEL FLOW: values clipping/total is cycling quickly
FIXED DECELERATE Message should appear as soon as TOD reached without descending
FIXED FWC Ordering Issue
FIXED INOP systems on ground in STS page that shouldn't be there
FIXED FWC "ADR 1+2+3"
FIXED Additional Info to ADIRUs OFF on Ground FWC - STS Page pre-engine-start behavior
FIXED GPWS and TERR FAULT lights
FIXED IR and ADR Pushbuttons logic
FIXED GND CLTR SPRS Switch logic
FIXED GND CLTR SPRS typo EIS1
FIXED Engine performance feedback
FIXED ELEC and HYD ECAM not resetting after engine restarted
FIXED ADR off/failure should also lead to ALT indication lost
FIXED ADR3 is feeding the FO ISO ADR2
FIXED EIS1: ND spd lim magenta dot off route
FIXED FL150 (ALT NAV) with FL410 on FCU and MACH SEL: .8 displayed, when pushing knob to engage CLB, selected speed suddenly became a MACH value
FIXED FMS - Approach didn't re-sequence correctly on go-around - adding SEC F-PLN to Active automatically after
FIXED STEP DELETED advisory logic revised
FIXED AIR ABNORMAL AIR BLEED ECAM missing but this would be good to get added quite quickly as this seems to come up all the time with failures
FIXED TAT + SAT + Bleed pressure (APU PAGE) information with ADIRS to NAV during alignment
FIXED GPS Jamming - GPWS Warning continues to play despite system being off
FIXED GPS Jamming - ECAM Actions not recognized
FIXED THR RED / ACCEL ALT capped at 10,000ft
FIXED ADR2 and ADR3 OFF lights not working
FIXED Regression: EIS1 THS should NOT automatically set after start
FIXED Autosave Interval not being respected properly
FIXED AOC RCVD Messages - 'Return to AOC Menu' button INOP when returning after viewing a received message
FIXED AOC RCVD Messages - Typo in header - Replace "RSVD" with "RCVD"
FIXED Planning very high speed for IF waypoint
FIXED Implement Constant Mach Number
FIXED SEC PLAN sequencing issue
FIXED VNAV still over-estimating drag/slowing ability on descent
FIXED RTE Reserve should become 0 when inflight
FIXED SEC PLAN PBD inserting is out of sequence
FIXED Des cabin rate value
FIXED MCDU FPLN times need to move one character to the left
FIXED Landing CAB ALT always = 0
FIXED ADR off should remove ALT indication
FIXED ADR off incorrectly removing VS indication
FIXED CLB page shows distance to next step climb during climb out
FIXED While entering a hold, Pause at TOD was activated
FIXED Clean speed capped at 257 kts
FIXED Manual leg after take off leads to incorrect total distance
FIXED Incorrect CHECK IRS/AIRPORT POS after DTO whilst on manual leg
FIXED Cycling FM DB not wiping MCDU
FIXED On initial load, lower FOB set by default
FIXED Battery test logic revised
FIXED NAV PRIMARY GPS LOSS whenever HDG is pulled
FIXED PERF APPR showing F, S, O speeds based on live weight instead of planned LW
FIXED PREV PHASE button on Wind page broken on ground
FIXED Rollout mode not disengaging
FIXED DDRMI missing second digit 0 when distance is 100–110 miles
FIXED SEC INIT Page missing INIT REQUEST
FIXED SEC PERF logic revision
FIXED MACH/SPD select logic
FIXED Hydraulic Panel Pushbuttons
FIXED ECAM SD always defaults to STATUS
FIXED Various systems working without electrical power
FIXED Time Marker logic
FIXED Engine out during take off: incorrect CLB phase sequencing logic
FIXED DCDU overlapping text after DM0 selection
FIXED Major: incorrect inop systems in STS on ground
FIXED C&D start with ADIRS off causes FD to turn ON when ADIRS line up
FIXED MAN CAB ALT resolution incorrect
FIXED Default CLB/DES SPD LIM should be small font
FIXED A340 Autobrake excessive deceleration rates
FIXED MCDU deleting DES SPD LIM behaviour
FIXED Audible detent at halfway point in SPD BRK lever
FIXED Oil Temp variance too large between engines
FIXED LAT REV tweaks
FIXED PERF/IDLE factors
FIXED INIT A formatting
FIXED IRS pages
FIXED Small tweaks on ENG SD Page
FIXED PERF T.O. Page
FIXED PERF CLB Page
FIXED PERF APPR Page
FIXED PERF GO AROUND Page
FIXED F-PLN A Page
FIXED F-PLN B Page
FIXED ETP Page (filled)
FIXED TAT and SAT orange when IR aligning (should be green)
FIXED EIS1 PFD ALT CSTR target bug random white line
FIXED EIS1 ND fpln behind present waypoint
FIXED EIS2 ND fpln behind from waypoint
FIXED EIS1: Pressing LS on ground should display course dagger in ND
FIXED EIS1 EWD showing
FIXED EIS1: landing at high elev airport, QNH flashing as if above TA
FIXED EIS2: After landing THS consistently oscillates
FIXED EIS1&2: MCDU missing EO ACCEL
FIXED EIS1&2: Vdev not stopping as half dot at top/bottom ALT scale
FIXED ISIS missing mach number
FIXED ISIS incorrect scrolling with +/-
FIXED EIS1: PFD incorrectly showing Vfe next with CONF FULL
ART 🎨
FIXED Missing paint on wing-roots (CPA)
FIXED Uneven spacing on one gray panel on flaps (both wings)
FIXED When flaps are down on new wing can see the mount for the flaps still in place
FIXED Offset Bake-marks below spoilers mechanism/arm
FIXED Wing-Walk Area (Black Lines) boundary broken
FIXED Right MLG small gear door clipping / not animating correctly
FIXED White painted wings (e.g. Lufthansa) need to be redone
FIXED Winglet paints (e.g. CPA) are offset from original position
FIXED Brakes light up with no heat generated
FIXED Lufthansa Old Liveries - Fuel line covers wrong color
FIXED Preighter - Slides deploy while taxiing in
FIXED APU missing heat blur
FIXED Increase Dirt/Weathering at "max" slider positions - currently too subtle
FIXED Wings / Slats modelling
FIXED Aileron Animations Feedback
FIXED Landing Gear, Doors & Mechanism issues
FIXED MLG collision on retraction
FIXED Flap length seems to differ when compared to the gear door and rivet line
FIXED Nose gear strut should not compress at any point during gear extension/retraction sequence
FIXED Outer flap incorrect TE shape
FIXED Outer engine pylon, wrong angle on TE of wing
FIXED Check flap track fairing angles
FIXED See through gap, underwing
FIXED Ailerons collide with wing on deflection
FIXED Flap track fairing, fairing<>flap gap
FIXED MLG door incorrect angle
FIXED Caution placards on both Pack outflow valves not moving with valve
FIXED MLG Front wheels start turning when aft wheels touch down
FIXED ENG and APU fire button light too pink
FIXED Wing strobes don’t generate a double flash halo
FIXED Sunshades missing tooltips
FIXED PAX windows too tinted
FIXED Not enough splash on wings from upper beacon light
FIXED R wing Nav & Strobe light effects repositioned
EFB💻
FIXED Regression – STOW RAT button does nothing
FIXED ICAO not sent to flight tracking apps
FIXED CPT/FO EFB Cabin Lighting Slider Not Synced
FIXED LIDO charts showing even if invalid
SOUNDS🔊
FIXED When pressing EMER EVAC no sound in cabin or cockpit
FIXED Missing EVAC sound
FIXED Windmill sounds missing
FIXED when you select AVNC EXT to OVRD and then ON you get the EXT power sound playing
FIXED EIS 2 gyro sounds audible on startup
FIXED Sounds: missing in glareshields
Wenn jemand die Bestätigung für Copy Pasta überlesen hat:
FIXED IR issue still not fixed and this is what caused drama on 350. When IR 1 is elected off the ATT for PFD 1 is lost same for IR 2 and FO PFD and follows the same logic on the ECAM SWTCH panel so you can use the IR INFO from IR 3 on either FO or CPT PFD
